<p>Using recycled aggregates in concrete and mortar reduces environmental impact by minimizing both natural aggregate consumption and construction waste disposal. 3D printing offers innovative, cost-efficient construction methods, but it heavily relies on cement and sand. This research aims to investigate the hard properties of 3D printing mortars made with 100% substitution of natural sand by recycled sand. The effects of sand substitution and 3D printing process on the hard properties of printable mortars are studied. The mechanical strength of moulded and printed specimens of printable mortars based on recycled sand were studied and compared with those made from a reference printable mortar based on natural sand. Additionally, the microstructure of mortars, namely the density of the interfacial transition zone in these specimens was analysed to understand the mechanical strength results. The results showed that both the incorporation of recycled sand and the 3D printing process had little effect on the mechanical strength. This could be attributed to the decrease in the density of the interfacial transition zone caused by both the incorporation of recycled sand and the mortar printing process. Furthermore, the study investigated also the effect of incorporating recycled sand on autogenous, drying, and total shrinkage. It was observed that this incorporation reduces the autogenous shrinkage at an early age, while it increases both dry and total shrinkage.</p>