Scholarlink

<p>Compression properties of three binary Ti–Mo alloys for potential use as load-bearing implants were investigated in this study. Three binary alloys, namely, Ti–15Mo, Ti–17Mo, and Ti–20Mo, were designed using theoretical predictive methods and produced using a plasma melting system. Melted ingots were heat treated in a muffle furnace at 1100&#xa0;°C for 1 h and quenched in ice brine water. X-ray diffraction patterns demonstrated <i>β</i> + <i>α</i>″ phase peaks, deformation mechanisms showed thin parallel plates in TM15, wide deformation bands, and wavy thin lines in TM17 and wavy thin lines only in TM20 alloy. Compressive yield and ultimate strength as well as hardness decreased with an increase in Mo content. On contrary, compression strain increased with increasing Mo content.</p> Graphical abstract <p></p>

错误：搜索内容不能为空，请输入英文关键词
错误：关键词超出字数限制，请精简
高级检索

Experimental investigation of compression properties of binary quenched Ti–Mo alloys for potential use as load-bearing implants

  • 期刊论文

  • 出版模式：

    开放获取

  • 发表日期：

    2025年4月18日

查看全文
  • N. A. Moshokoa,
  • M. L. Raganya,
  • N. W. Makoana,
  • D. Mkhonto,
  • M. J. Phasha,
  • M. E. Makhatha

摘要

Compression properties of three binary Ti–Mo alloys for potential use as load-bearing implants were investigated in this study. Three binary alloys, namely, Ti–15Mo, Ti–17Mo, and Ti–20Mo, were designed using theoretical predictive methods and produced using a plasma melting system. Melted ingots were heat treated in a muffle furnace at 1100 °C for 1 h and quenched in ice brine water. X-ray diffraction patterns demonstrated β + α″ phase peaks, deformation mechanisms showed thin parallel plates in TM15, wide deformation bands, and wavy thin lines in TM17 and wavy thin lines only in TM20 alloy. Compressive yield and ultimate strength as well as hardness decreased with an increase in Mo content. On contrary, compression strain increased with increasing Mo content.

Graphical abstract