Effect of different polishing systems on surface roughness and gloss values of single-shade resin composites

The aim of this study was to evaluate variations in the surface roughness and gloss of different single-shade resin composites after polishing with a range of systems.

In total, 120 specimens were prepared from three different types of single-shade resin composites (supra-nanospherical—Omnichroma, nanohybrid—Charisma Diamond One, and microhybrid— Essentia Universal). The specimens were placed in distilled water and stored at 37 °C for 24 h. Each resin composite (n = 40) was divided into four groups (n = 10) according to the finishing/polishing (F/P) system: Mylar strip (control), Sof-Lex (multi-step), Twist Dia (two-step), and OneGloss (one-step). Surface roughness and gloss were measured. Surface characteristics were evaluated by atomic force microscopy (AFM) and a scanning electron microscope (SEM). A two-way analysis of variance (ANOVA) and Tukey’s honestly significant difference test were used for statistical analysis (p < 0.05).

Among all the composites, both the highest surface roughness and lowest gloss values were obtained in the groups treated with the OneGloss polishing system (p < 0.05). Compared with all the composites, Omnichroma had the lowest surface roughness and highest gloss values (except Twist Dia) both unpolished and after polishing with all the F/P systems (p < 0.05). All composites treated with the Twist Dia F/P system had similar gloss values. The results of the AFM and SEM analyses were consistent with the surface roughness measurements.

The gloss values of both the microhybrid and nanohybrid composites after F/P using the two-step system was superior to that of the traditional multistep system. The surface of the supra-nanofilled resin-based composite was smoother than that of both the microhybrid and nanohybrid composites.