How does the position of the pelvis and femur influence the selection of prosthesis size during 2D preoperative planning for total hip arthroplasty?

Total Hip Arthroplasty (THA) is the primary treatment for hip diseases today. Nevertheless, total hip arthroplasty has its challenges, and one of these challenges is the potential for incorrect execution of the preoperative planning process. Such errors can lead to complications such as loosening and instability of the prosthesis and leg length discrepancy. In this study, we used human phantoms to investigate the influence of pelvic and femoral factors on prosthesis size selection in the preoperative planning of total hip arthroplasty and to provide a reference standard for clinical imaging in preoperative planning of total hip arthroplasty.

In this experiment, we utilised a custom-made experimental device that enabled us to manipulate the movement of the pelvis and femur in various directions. The device also incorporated sensors to control the angle of movement. By obtaining X-rays from different positions and angles, we were able to determine the size of the prosthesis based on the 2D preoperative planning generated by the mediCAD software.

When the pelvis was in a nonneutral position, the size of the acetabular cup varied within a range of three sizes. Similarly, when the femur was in a nonneutral position, the size of the femoral stem varied within a range of two sizes. The movement of the pelvis and femur in the coronal plane, relative to the neutral position, did not impact the selection of the prosthesis size. However, the motion of the pelvis and femur in the sagittal and transverse planes had a notable effect.

The selection of the prosthesis size for preoperative planning can be significantly influenced by specific positions of the pelvis and femur. It is crucial for the radiographer to ensure that the pelvis and femur maintain a standard neutral position, particularly in the sagittal and transverse planes, during the image acquisition process.