Scholarlink

Abstract <p>This article presents the results of an experimental assessment of the influence of the layout scheme on the tooling surface of tubes used to supply the binder and create a vacuum during the molding of parts from polymer composites using vacuum infusion technology. Epoxy binder and basalt fabric were used as the starting materials. Several options are considered, and tube installation schemes and results of phase composition and porosity of the resulting basalt plastics are presented.</p>

错误：搜索内容不能为空，请输入英文关键词
错误：关键词超出字数限制，请精简
高级检索

A Study of the Influence of Technological Support on the Quality of the Process of Forming Parts from Reinforced Plastics Using Vacuum Infusion Technology

  • 期刊论文

  • 发表日期：

    2025年3月1日

查看全文
  • E. S. Chaplina,
  • I. A. Makagonov,
  • D. D. Tarasov,
  • M. V. Boyarchuk,
  • A. S. Borodulin

摘要

Abstract

This article presents the results of an experimental assessment of the influence of the layout scheme on the tooling surface of tubes used to supply the binder and create a vacuum during the molding of parts from polymer composites using vacuum infusion technology. Epoxy binder and basalt fabric were used as the starting materials. Several options are considered, and tube installation schemes and results of phase composition and porosity of the resulting basalt plastics are presented.