Characterization of Tracking Modules Based on DSSD Sensors at the SC-1000 Accelerator for the BM@N Project

The results of studying characteristics of modules based on double-sided microstrip silicon sensors, which are designed to create the wide-aperture Silicon Tracking System for the BM@N facility, are presented. The main module features are the use of fast readout electronics based on the STS-XYTER chip and the application of ultralight (0.23% X₀) aluminum microcables for transmitting analog signals from the sensor strips to the input channels of the readout electronics. The results of testing different configurations of tracking modules on the extracted beam of protons at the SC-1000 accelerator in the PNPI are presented. The stable operation of readout electronics is demonstrated at loads close to the maximum values of 360 kHz s^–1 cm^–2. The signal-to-noise ratio was no less than 23. The measured coordinate resolution of the modules within the beam telescope was 17 ± 0.4 μm, and the detector efficiency of recording for protons with energy of 1 GeV was no less than 99%.