Scholarlink

Abstract <p>The electrochemical machining (ECM) of the outer surface of rotating cylindrical workpiece using a cylindrical cathode with a partially insulated surface is simulated. It is shown that partial insulation of tool electrode (TE) surface enables increasing the localization of the metal dissolution on the desired area of the workpiece surface. The degree of localization increases with a decrease of the non-insulated TE part and a decrease of the minimal interelectrode gap used in ECM. Partial insulation of TE surface leads to a certain decrease in the ECM productivity; however, the edge effect at the boundary between the insulated and non-insulated parts of TE partially compensates for this drawback.</p>

错误：搜索内容不能为空，请输入英文关键词
错误：关键词超出字数限制，请精简
高级检索

Modeling of Electrochemical Machining of Cylindrical Surfaces Using Partially Insulated Tool Cathode

  • 期刊论文

  • 发表日期：

    2025年7月1日

查看全文
  • V. M. Volgin,
  • I. V. Gnidina,
  • T. B. Kabanova,
  • V. N. Andreev,
  • A. D. Davydov

摘要

Abstract

The electrochemical machining (ECM) of the outer surface of rotating cylindrical workpiece using a cylindrical cathode with a partially insulated surface is simulated. It is shown that partial insulation of tool electrode (TE) surface enables increasing the localization of the metal dissolution on the desired area of the workpiece surface. The degree of localization increases with a decrease of the non-insulated TE part and a decrease of the minimal interelectrode gap used in ECM. Partial insulation of TE surface leads to a certain decrease in the ECM productivity; however, the edge effect at the boundary between the insulated and non-insulated parts of TE partially compensates for this drawback.