Scholarlink

Abstract <p>The process of searching for a method of plastic deformation of steel spiral drill collars (SDCs), the external surface of which has fins with a high spiral pitch angle, is considered. A heuristic procedure of searching for technical solution satisfying a given restriction system is presented. Then, on this base, it is recommended to consider two versions of manufacturing, which are then modeled using a finite element method. It is proposed to subject these pipes to rolling in three rolls with their oblique arrangement with respect to the rolling axis and gradient heating the pipe body before a shaping stand. The fins are formed in the gap between the roll ends. The metal forming is determined at a given fin configuration. All geometric and energy power parameters of the process required for designing equipment are also determined.</p>

错误：搜索内容不能为空，请输入英文关键词
错误：关键词超出字数限制，请精简
高级检索

Choice of Technological Parameters for Manufacturing Spiral Drill Collars

  • 期刊论文

  • 发表日期：

    2025年5月1日

查看全文
  • S. V. Parshin,
  • A. A. Parshina,
  • A. I. Dronov

摘要

Abstract

The process of searching for a method of plastic deformation of steel spiral drill collars (SDCs), the external surface of which has fins with a high spiral pitch angle, is considered. A heuristic procedure of searching for technical solution satisfying a given restriction system is presented. Then, on this base, it is recommended to consider two versions of manufacturing, which are then modeled using a finite element method. It is proposed to subject these pipes to rolling in three rolls with their oblique arrangement with respect to the rolling axis and gradient heating the pipe body before a shaping stand. The fins are formed in the gap between the roll ends. The metal forming is determined at a given fin configuration. All geometric and energy power parameters of the process required for designing equipment are also determined.