Scholarlink

Abstract <p>Hot compression experiments were conducted on AISI-304L austenitic stainless steel at strain rates of 0.01 and 10 s<sup>–1</sup> within the temperature range of 900 to 1200°C, up to a strain of 0.69. Discontinuous dynamic recrystallization (DDRX) plays a significant role in the hot deformation process of AISI 304L ASS, while continuous dynamic recrystallization (CDRX) only plays a synergistic role. As the deformation temperature rises, the fraction of recrystallization (RX) nucleation consistently increases. At the same deformation temperature, the fraction of RX first decreases and then increases with increasing strain rate. The higher fraction of RX occurs at lower strain rates because more deformation time is available for grain boundary migration. At a higher strain rate, the higher stored energy, adiabatic temperature rise (ATR), and post-dynamic recrystallization (PDRX) promote the RX process.&#xa0;Flow stress curves were revised considering the effects of adiabatic heating during hot deformation. The results showed that ATR is improved with increased strain level attained, strain rate, and temperature decrease.</p>

错误：搜索内容不能为空，请输入英文关键词
错误：关键词超出字数限制，请精简
高级检索

Flow Softening and Microstructure Evolution of Austenitic Stainless Steel during Hot Compression

  • 期刊论文

  • 发表日期：

    2025年1月1日

查看全文
  • Jian Huang,
  • Zong Xu Pang,
  • Jian Ping Zhang,
  • Yong Wang,
  • Li Li Zhong,
  • Bao Chun Zhao

摘要

Abstract

Hot compression experiments were conducted on AISI-304L austenitic stainless steel at strain rates of 0.01 and 10 s–1 within the temperature range of 900 to 1200°C, up to a strain of 0.69. Discontinuous dynamic recrystallization (DDRX) plays a significant role in the hot deformation process of AISI 304L ASS, while continuous dynamic recrystallization (CDRX) only plays a synergistic role. As the deformation temperature rises, the fraction of recrystallization (RX) nucleation consistently increases. At the same deformation temperature, the fraction of RX first decreases and then increases with increasing strain rate. The higher fraction of RX occurs at lower strain rates because more deformation time is available for grain boundary migration. At a higher strain rate, the higher stored energy, adiabatic temperature rise (ATR), and post-dynamic recrystallization (PDRX) promote the RX process. Flow stress curves were revised considering the effects of adiabatic heating during hot deformation. The results showed that ATR is improved with increased strain level attained, strain rate, and temperature decrease.