Scholarlink

<p>This study presents a comprehensive investigation of electrical discharge machining (EDM) applied to Al-SiC metal matrix composites (MMCs), focusing on the comparative performance of copper and graphite tool electrodes. Material removal rate (MRR) and tool wear rate (TWR) were considered as the primary response variables, while current, pulse-on time (T<sub>ON</sub>), and pulse-off time (T<sub>OFF</sub>) served as the controlling parameters. A Box–Behnken experimental design was employed to construct the design matrix, and analysis of variance (ANOVA) was used to evaluate the statistical significance of the process variables. Results indicate that both current and T<sub>ON</sub> exert a strong influence on MRR and TWR, whereas increasing T<sub>OFF</sub> consistently reduces TWR for both electrodes. Overall, copper electrodes demonstrated superior machinability, offering up to 18% higher MRR and 25% lower TWR compared to graphite. These findings establish copper as a more efficient tool material for EDM of Al–SiC MMCs and provide practical guidelines for optimizing EDM parameters to enhance productivity and reduce tool wear in composite machining applications.</p>

错误：搜索内容不能为空，请输入英文关键词
错误：关键词超出字数限制，请精简
高级检索

Comparative analysis of copper and graphite electrodes in EDM of Al–SiC metal matrix composites

  • 期刊论文

  • 出版模式：

    开放获取

  • 发表日期：

    2026年1月30日

查看全文
  • Bharat Shahapur,
  • Debabrata Barik,
  • Himadri Majumder,
  • Ayyar Dinesh,
  • Saravanan Rajendran,
  • N. Ashok

摘要

This study presents a comprehensive investigation of electrical discharge machining (EDM) applied to Al-SiC metal matrix composites (MMCs), focusing on the comparative performance of copper and graphite tool electrodes. Material removal rate (MRR) and tool wear rate (TWR) were considered as the primary response variables, while current, pulse-on time (TON), and pulse-off time (TOFF) served as the controlling parameters. A Box–Behnken experimental design was employed to construct the design matrix, and analysis of variance (ANOVA) was used to evaluate the statistical significance of the process variables. Results indicate that both current and TON exert a strong influence on MRR and TWR, whereas increasing TOFF consistently reduces TWR for both electrodes. Overall, copper electrodes demonstrated superior machinability, offering up to 18% higher MRR and 25% lower TWR compared to graphite. These findings establish copper as a more efficient tool material for EDM of Al–SiC MMCs and provide practical guidelines for optimizing EDM parameters to enhance productivity and reduce tool wear in composite machining applications.