Scholarlink

<p>Concentrated Solar Power (CSP) is a powerful tool for simulating the extreme high-temperature conditions that metallic materials encounter. Using a vertical parabolic solar furnace, it was possible to perform heating and cooling cycles between 250 and 950&#xa0;°C in approximately 250 s per cycle. This capability is particularly relevant for the development of solar receivers used in solar thermal plants. Additive Manufacturing (AM) offers the potential to create new compositions and geometries that can enhance the efficiency of these solar receivers. In this study, Ni-base superalloys—identified as suitable materials for high-temperature solar receivers—were produced using AM and tested in two conditions: as-built and after thermal treatment. These were compared with a forged reference alloy. The results revealed the formation of a protective oxide layer on the surface in all cases. However, the oxide layer on the samples fabricated by additive manufacturing appeared to be more compact and adherent compared to that formed on the reference alloy.</p>

错误：搜索内容不能为空，请输入英文关键词
错误：关键词超出字数限制，请精简
高级检索

Thermal shock resistance of additive manufactured Inconel 718 by concentrated solar energy

  • 期刊论文

  • 出版模式：

    开放获取

  • 发表日期：

    2025年3月4日

查看全文
  • Juan de Damborenea,
  • Ana Conde,
  • Gloria Rodriguez-Donoso,
  • Fernando Agulló-Rueda,
  • Maria Angeles Arenas

摘要

Concentrated Solar Power (CSP) is a powerful tool for simulating the extreme high-temperature conditions that metallic materials encounter. Using a vertical parabolic solar furnace, it was possible to perform heating and cooling cycles between 250 and 950 °C in approximately 250 s per cycle. This capability is particularly relevant for the development of solar receivers used in solar thermal plants. Additive Manufacturing (AM) offers the potential to create new compositions and geometries that can enhance the efficiency of these solar receivers. In this study, Ni-base superalloys—identified as suitable materials for high-temperature solar receivers—were produced using AM and tested in two conditions: as-built and after thermal treatment. These were compared with a forged reference alloy. The results revealed the formation of a protective oxide layer on the surface in all cases. However, the oxide layer on the samples fabricated by additive manufacturing appeared to be more compact and adherent compared to that formed on the reference alloy.