Scholarlink

<p>NiO, a wide band gap hole-transporting material (HTM), is gaining attention in photovoltaics due to its optical transparency, chemical stability, and favourable band alignment with absorber. This study uses NiO<sub>x</sub> nanoparticle-based HTM in semi-transparent Sb<sub>2</sub>S<sub>3</sub> solar cells via a simple chemical precipitation method. We optimised NiO<sub>x</sub> layer by varying precursor solution concentration and studied its impact on optical and structural properties, composition of nanoparticles and subsequent effect on the performance of semi-transparent Sb<sub>2</sub>S<sub>3</sub> solar cell. NiO<sub>x</sub> nanoparticles, deposited from nickel(II)nitrate hexahydrate (precursor solution concentrations of 0.2&#xa0;M to 1.2&#xa0;M), were thermally treated by two steps at 90&#xa0;°C for 6&#xa0;h and 270&#xa0;°C for 3&#xa0;h. Nanoparticles with crystallite sizes of 6–9&#xa0;nm had band gaps (Eg) of ca. 3.65–3.70&#xa0;eV. Using 1.2&#xa0;M concentration yielded the largest crystallites (9&#xa0;nm), lowest Eg (3.65&#xa0;eV) while retaining the most precursor residues. The highest power conversion efficiency (2.68%) was achieved with NiO<sub>x</sub> from a 0.5&#xa0;M precursor, a 60% improvement over HTM-free cells. The effect of precursor solution concentration on the solar cell parameters (efficiency, fill factor, open circuit voltage and short circuit current) are discussed. Present work paves a path toward stable, efficient, and cost-effective all-inorganic Sb<sub>2</sub>S<sub>3</sub> solar cells using NiO<sub>x</sub> HTM instead of organic counterparts.</p>

错误：搜索内容不能为空，请输入英文关键词
错误：关键词超出字数限制，请精简
高级检索

Towards all inorganic antimony sulphide semitransparent solar cells

  • 期刊论文

  • 出版模式：

    开放获取

  • 发表日期：

    2025年1月9日

查看全文
  • Alka Pareek,
  • Atanas Katerski,
  • Merike Kriisa,
  • Nicolae Spalatu,
  • Malle Krunks,
  • Ilona Oja Acik

摘要

NiO, a wide band gap hole-transporting material (HTM), is gaining attention in photovoltaics due to its optical transparency, chemical stability, and favourable band alignment with absorber. This study uses NiOx nanoparticle-based HTM in semi-transparent Sb2S3 solar cells via a simple chemical precipitation method. We optimised NiOx layer by varying precursor solution concentration and studied its impact on optical and structural properties, composition of nanoparticles and subsequent effect on the performance of semi-transparent Sb2S3 solar cell. NiOx nanoparticles, deposited from nickel(II)nitrate hexahydrate (precursor solution concentrations of 0.2 M to 1.2 M), were thermally treated by two steps at 90 °C for 6 h and 270 °C for 3 h. Nanoparticles with crystallite sizes of 6–9 nm had band gaps (Eg) of ca. 3.65–3.70 eV. Using 1.2 M concentration yielded the largest crystallites (9 nm), lowest Eg (3.65 eV) while retaining the most precursor residues. The highest power conversion efficiency (2.68%) was achieved with NiOx from a 0.5 M precursor, a 60% improvement over HTM-free cells. The effect of precursor solution concentration on the solar cell parameters (efficiency, fill factor, open circuit voltage and short circuit current) are discussed. Present work paves a path toward stable, efficient, and cost-effective all-inorganic Sb2S3 solar cells using NiOx HTM instead of organic counterparts.