Scholarlink

<p>The article studies the issues involved in refining aluminium alloys when introducing small gas bubbles. A good level of dispersion throughout the entire volume of the degassing unit is achieved by using appropriate rotor geometry and selecting optimal process parameters. This study uses physical modelling employing a water model of a foundry degassing unit. Three pump-type rotors of different designs were tested. Variants A and C with a circular cross-section and cylindrical shape differ in the design and arrangement of the gas flow control blades, while variant B with the shape of a truncated cone is a kind of monolith with control blades placed in the lower part of the rotor. These rotors with were studied, with gas flows ranging from 13 to 21&#xa0;l/min and rotor speeds ranging from 275 to 425&#xa0;rpm. Tests included visualisation of the gas injection process and measurement of oxygen removal from water as an analogy of hydrogen removal from liquid metal. Then a mathematical model for the quantitative interpretation of research results was developed, in which the dimensionless parameter of degassing efficiency <i>a</i> was determined, which allows for a simple comparison of its value for all rotors, both new and used. The highest values of parameter <i>a</i> are observed for rotor C, only slightly worse values occur for rotor A, and the most significant differences are visible for rotor B. The research results were validated under industrial conditions – the Dichte Index was calculated for all rotors for selected process parameters and illustrated with porosity samples.</p>

错误：搜索内容不能为空，请输入英文关键词
错误：关键词超出字数限制，请精简
高级检索

Efficiency of aluminium refining on a foundry degassing unit depending on the rotor geometry and the degree of its wear

  • 期刊论文

  • 出版模式：

    开放获取

  • 发表日期：

    2025年7月22日

查看全文
  • Jan Kolínský,
  • Ladislav Socha,
  • Jana Sviželová,
  • Tomáš Prášil,
  • Mariola Saternus,
  • Tomasz Merder,
  • Jacek Pieprzyca,
  • Josef Häusler

摘要

The article studies the issues involved in refining aluminium alloys when introducing small gas bubbles. A good level of dispersion throughout the entire volume of the degassing unit is achieved by using appropriate rotor geometry and selecting optimal process parameters. This study uses physical modelling employing a water model of a foundry degassing unit. Three pump-type rotors of different designs were tested. Variants A and C with a circular cross-section and cylindrical shape differ in the design and arrangement of the gas flow control blades, while variant B with the shape of a truncated cone is a kind of monolith with control blades placed in the lower part of the rotor. These rotors with were studied, with gas flows ranging from 13 to 21 l/min and rotor speeds ranging from 275 to 425 rpm. Tests included visualisation of the gas injection process and measurement of oxygen removal from water as an analogy of hydrogen removal from liquid metal. Then a mathematical model for the quantitative interpretation of research results was developed, in which the dimensionless parameter of degassing efficiency a was determined, which allows for a simple comparison of its value for all rotors, both new and used. The highest values of parameter a are observed for rotor C, only slightly worse values occur for rotor A, and the most significant differences are visible for rotor B. The research results were validated under industrial conditions – the Dichte Index was calculated for all rotors for selected process parameters and illustrated with porosity samples.