Scholarlink

<p>EN-GJS-400–15 (GGG40) ductile irons were alloyed with Mo (0, 0.25, 0.5, 1, and 2&#xa0;wt.%), and ten variants were produced by casting in Y-block sand molds with section thicknesses of 12.5&#xa0;mm and 25&#xa0;mm. Microstructural characterization was conducted using FESEM, EDX, optical microscopy, and Clemex image analysis. Mechanical and tribological properties were evaluated through hardness, tensile, and ball-on-disk wear tests. The addition of Mo promoted carbide formation at grain boundaries—predominantly M<sub>7</sub>C<sub>3</sub> in the thinner sections and M<sub>23</sub>C<sub>6</sub> in the thicker ones—along with an increased pearlite content in the matrix. These changes enhanced hardness, ultimate tensile strength, and yield strength, though at the expense of ductility. Under an 18 N load against an Al<sub>2</sub>O<sub>3</sub> counterface, the 2&#xa0;wt.% Mo alloy exhibited approximately a 65% reduction in wear rate compared to the unalloyed baseline. Surface analysis revealed adhesive, abrasive, and oxidative wear mechanisms. Overall, the 2&#xa0;wt.% Mo alloy demonstrated the most favorable balance of mechanical strength and wear resistance.</p>

错误：搜索内容不能为空，请输入英文关键词
错误：关键词超出字数限制，请精简
高级检索

Combined Effects of Molybdenum and Cooling Rate on Microstructure and Tribo-Mechanical Properties of Ductile Iron

  • 期刊论文

  • 发表日期：

    2025年10月13日

查看全文
  • Kübra Kaymak,
  • Kübra Çelik,
  • Ahmet Buğra Keyvanklı,
  • Rıdvan Gecü

摘要

EN-GJS-400–15 (GGG40) ductile irons were alloyed with Mo (0, 0.25, 0.5, 1, and 2 wt.%), and ten variants were produced by casting in Y-block sand molds with section thicknesses of 12.5 mm and 25 mm. Microstructural characterization was conducted using FESEM, EDX, optical microscopy, and Clemex image analysis. Mechanical and tribological properties were evaluated through hardness, tensile, and ball-on-disk wear tests. The addition of Mo promoted carbide formation at grain boundaries—predominantly M7C3 in the thinner sections and M23C6 in the thicker ones—along with an increased pearlite content in the matrix. These changes enhanced hardness, ultimate tensile strength, and yield strength, though at the expense of ductility. Under an 18 N load against an Al2O3 counterface, the 2 wt.% Mo alloy exhibited approximately a 65% reduction in wear rate compared to the unalloyed baseline. Surface analysis revealed adhesive, abrasive, and oxidative wear mechanisms. Overall, the 2 wt.% Mo alloy demonstrated the most favorable balance of mechanical strength and wear resistance.