Scholarlink

<p>Magnesium (Mg)-based nanocomposites are increasingly used for different applications, including the mechanical and aeronautical industries. In this paper, double-sided pressing was used to fabricate the nanocomposite discs. Various physical properties and the microstructure of these nanocomposites, reinforced with 1.5%, 3%, and 5% aluminum oxide (Al<sub>2</sub>O<sub>3</sub>) nanoparticles, were investigated and compared with the case of pure Mg powder without nanoparticles. Nanocomposite discs were prepared at 250, 500, and 750&#xa0;MPa, and then sintered at 450&#xa0;°C for one hour under an atmosphere of argon (99.995%) and hydrogen (0.005%). The density, microhardness, and wear rate of the nanocomposite specimens were carefully evaluated and discussed. Polarization curves were plotted to examine the corrosion rate of the nanocomposite discs. The microstructures of the nanocomposite discs were evaluated using a scanning electron microscope (SEM). The results showed that, due to the uniform dispersion of nanoparticles in the Mg powder, the reinforcement of 3% Al<sub>2</sub>O<sub>3</sub> nanoparticles in the nanocomposite discs led to high microhardness and corrosion resistance. The cases with 5% Al<sub>2</sub>O<sub>3</sub> showed the accumulation and agglomeration of nanoparticles at grain boundaries, resulting in a reduction of microhardness and wear resistance compared to the ones with 3% nanoparticles.</p>

错误：搜索内容不能为空，请输入英文关键词
错误：关键词超出字数限制，请精简
高级检索

Fabrication and Characterization of Magnesium-Based Nanocomposite Discs Reinforced with Al2O3 Nanoparticles

  • 期刊论文

  • 发表日期：

    2026年1月16日

查看全文
  • A. Adelkhani,
  • E. Daneshkhah

摘要

Magnesium (Mg)-based nanocomposites are increasingly used for different applications, including the mechanical and aeronautical industries. In this paper, double-sided pressing was used to fabricate the nanocomposite discs. Various physical properties and the microstructure of these nanocomposites, reinforced with 1.5%, 3%, and 5% aluminum oxide (Al2O3) nanoparticles, were investigated and compared with the case of pure Mg powder without nanoparticles. Nanocomposite discs were prepared at 250, 500, and 750 MPa, and then sintered at 450 °C for one hour under an atmosphere of argon (99.995%) and hydrogen (0.005%). The density, microhardness, and wear rate of the nanocomposite specimens were carefully evaluated and discussed. Polarization curves were plotted to examine the corrosion rate of the nanocomposite discs. The microstructures of the nanocomposite discs were evaluated using a scanning electron microscope (SEM). The results showed that, due to the uniform dispersion of nanoparticles in the Mg powder, the reinforcement of 3% Al2O3 nanoparticles in the nanocomposite discs led to high microhardness and corrosion resistance. The cases with 5% Al2O3 showed the accumulation and agglomeration of nanoparticles at grain boundaries, resulting in a reduction of microhardness and wear resistance compared to the ones with 3% nanoparticles.