Scholarlink

<p>In this study, we have developed a biodegradable Mg-Zn alloy with good strength and elongation. Various Mg alloys have been developed over the years because of their excellent properties and biodegradability. However, their limited elongation and rapid corrosion limit their widespread use. In this study, a Mg-3 wt.% Zn alloy was developed, and its mechanical and corrosion properties were evaluated. The cast and solution-heat-treated Mg-3 wt.% Zn alloys were extruded from 180 to 350°C. The ultimate tensile strength and yield stress exhibited maximum increase at 180°C, while strain exhibited maximum increase at 200°C. The minimum corrosion rate was also observed at 200°C. However, the alloy extruded at 180°C showed rapid corrosion during in vitro evaluation because of a second phase that precipitated during extrusion. The enhanced performance of the Mg–3 wt.% Zn alloys was attributed to grain refinement, which increased the mechanical properties by grain boundary strengthening and twinning and the corrosion resistance due to the rapid passivation kinetics.</p>

错误：搜索内容不能为空，请输入英文关键词
错误：关键词超出字数限制，请精简
高级检索

Development of Biodegradable Mg-Zn Alloys by Grain Refinement Through Extrusion

  • 期刊论文

  • 发表日期：

    2025年2月10日

查看全文
  • GuangZhe Li,
  • Hee-Young Kwon,
  • Byeong-Chan Suh,
  • Hyung-Seop Han,
  • HoJeong Jeon,
  • Pil-Ryung Cha,
  • Dong-Ik Kim,
  • Hyun-Kwang Seok,
  • Yu-Chan Kim

摘要

In this study, we have developed a biodegradable Mg-Zn alloy with good strength and elongation. Various Mg alloys have been developed over the years because of their excellent properties and biodegradability. However, their limited elongation and rapid corrosion limit their widespread use. In this study, a Mg-3 wt.% Zn alloy was developed, and its mechanical and corrosion properties were evaluated. The cast and solution-heat-treated Mg-3 wt.% Zn alloys were extruded from 180 to 350°C. The ultimate tensile strength and yield stress exhibited maximum increase at 180°C, while strain exhibited maximum increase at 200°C. The minimum corrosion rate was also observed at 200°C. However, the alloy extruded at 180°C showed rapid corrosion during in vitro evaluation because of a second phase that precipitated during extrusion. The enhanced performance of the Mg–3 wt.% Zn alloys was attributed to grain refinement, which increased the mechanical properties by grain boundary strengthening and twinning and the corrosion resistance due to the rapid passivation kinetics.