Scholarlink

<p>We present an interesting low-cost, green, and scalable technique for direct ink writing for flexible electronic applications different from traditional fabrication techniques. In this work, a reduced graphene oxide (RGO)-bismuth oxide (Bi<sub>2</sub>O<sub>3</sub>)/carbon nanotube (CNT) (RGBC) ternary conductive ink was prepared by an initial synthesis of RGO-Bi<sub>2</sub>O<sub>3</sub> (RGB) via a hydrothermal method. This was followed by the fabrication of conductive ink through homogenous mixing of the binary nanocomposite with CNTs in a mixture of ethanol, ethylene glycol, glycerol, and double-distilled water as the solvent. Electronic circuits were fabricated through directly writing the prepared ink on flexible nanocrystalline cellulose (NCC) thin film substrates. The nanocomposites consisted of rod-shaped nanoparticles that were grown on the surface of the nanographene sheet. The semiconductor nanocomposite exhibited excellent conductivity and further confirmed by applying it as an electrode in the electrical circuit to light a light-emitting diode (LED) bulb. The highest electrical conductivity achieved was 2.84 × 10<sup>3</sup> S·m<sup>−1</sup> with a contact angle of 37°. The electronic circuit written using the conductive ink exhibited good homogeneity, uniformity, and adhesion. The LED experiment demonstrates the good conductivity of the electroconductive circuit and prepared ink. Hence, the NCC substrate and RGBC conductive ink showcase an excellent potential for flexible electronic applications.</p>

错误：搜索内容不能为空，请输入英文关键词
错误：关键词超出字数限制，请精简
高级检索

An electroconductive ink containing the reduced graphene oxide-metal oxide-carbon nanotube semiconductor applied to flexible electronic circuits

  • 期刊论文

  • 发表日期：

    2025年3月12日

查看全文
  • Hassan Oriyomi Shoyiga,
  • Bice Suzan Martincigh,
  • Vincent Onserio Nyamori

摘要

We present an interesting low-cost, green, and scalable technique for direct ink writing for flexible electronic applications different from traditional fabrication techniques. In this work, a reduced graphene oxide (RGO)-bismuth oxide (Bi2O3)/carbon nanotube (CNT) (RGBC) ternary conductive ink was prepared by an initial synthesis of RGO-Bi2O3 (RGB) via a hydrothermal method. This was followed by the fabrication of conductive ink through homogenous mixing of the binary nanocomposite with CNTs in a mixture of ethanol, ethylene glycol, glycerol, and double-distilled water as the solvent. Electronic circuits were fabricated through directly writing the prepared ink on flexible nanocrystalline cellulose (NCC) thin film substrates. The nanocomposites consisted of rod-shaped nanoparticles that were grown on the surface of the nanographene sheet. The semiconductor nanocomposite exhibited excellent conductivity and further confirmed by applying it as an electrode in the electrical circuit to light a light-emitting diode (LED) bulb. The highest electrical conductivity achieved was 2.84 × 103 S·m−1 with a contact angle of 37°. The electronic circuit written using the conductive ink exhibited good homogeneity, uniformity, and adhesion. The LED experiment demonstrates the good conductivity of the electroconductive circuit and prepared ink. Hence, the NCC substrate and RGBC conductive ink showcase an excellent potential for flexible electronic applications.