Scholarlink

<p>This study investigated the deformation resistance of selective laser melting AlSi10Mg against the applied load and its behavior against bending after local heating. In experimental studies, the bending region of the samples was heated locally at temperatures of 300, 400, and 500&#xa0;°C and then deformed in V bending dies of 6, 7.5, 9, and 15 degrees. It was observed that the deformation resistance of the samples was sufficient in the dies of 6, 7.5, and 9 degrees and at all temperatures. Therefore, the samples did not flex or break successfully. However, it was observed that at a die angle of 15, only the test samples at RT and 300&#xa0;°C showed sufficient deformation resistance and flexed successfully, while at 400 and 500&#xa0;°C temperatures, they could not withstand deformation and broke. The study also examined the effect of district heating temperature on the microstructure. In as-built samples, it was observed that the microstructure was centric at room temperature (RT), and the microhardness value was 131&#xa0;HV. At the regional heating temperature of 300&#xa0;°C, it was observed that there was no significant change in the microstructure, and the microhardness value was measured as 130&#xa0;HV. However, at 400&#xa0;°C regional heating, it was determined that the dendritic structure started to be replaced by precipitated Si particles, and the microhardness value decreased to 127&#xa0;HV. It was determined that at 500&#xa0;°C, the microhardness value decreased to 125&#xa0;HV due to the growth of the grain structure in the microstructure.</p>

错误：搜索内容不能为空，请输入英文关键词
错误：关键词超出字数限制，请精简
高级检索

Increasing of Deformation Strength: Evaluating of Local Heating on Selective Laser-Melted AlSi10Mg

  • 期刊论文

  • 发表日期：

    2025年2月5日

查看全文
  • Kadir Aydin,
  • İbrahim Karaağaç,
  • Mehmet Okan Kabakçi,
  • Bayram Sercan Bayram

摘要

This study investigated the deformation resistance of selective laser melting AlSi10Mg against the applied load and its behavior against bending after local heating. In experimental studies, the bending region of the samples was heated locally at temperatures of 300, 400, and 500 °C and then deformed in V bending dies of 6, 7.5, 9, and 15 degrees. It was observed that the deformation resistance of the samples was sufficient in the dies of 6, 7.5, and 9 degrees and at all temperatures. Therefore, the samples did not flex or break successfully. However, it was observed that at a die angle of 15, only the test samples at RT and 300 °C showed sufficient deformation resistance and flexed successfully, while at 400 and 500 °C temperatures, they could not withstand deformation and broke. The study also examined the effect of district heating temperature on the microstructure. In as-built samples, it was observed that the microstructure was centric at room temperature (RT), and the microhardness value was 131 HV. At the regional heating temperature of 300 °C, it was observed that there was no significant change in the microstructure, and the microhardness value was measured as 130 HV. However, at 400 °C regional heating, it was determined that the dendritic structure started to be replaced by precipitated Si particles, and the microhardness value decreased to 127 HV. It was determined that at 500 °C, the microhardness value decreased to 125 HV due to the growth of the grain structure in the microstructure.