Scholarlink

<p>The degradation performance of pervious concrete containing TiO<sub>2</sub>/LDHs-loaded recycled aggregates for NO gas was analyzed using a gas phase catalytic degradation test device, simulating different environmental conditions such as load, ambient temperature, and illumination intensity, which provides theoretical support for practical engineering. The experimental results indicate that when the ambient temperature is controlled at 25 °C and the illumination intensity is 30 W/m<sup>2</sup>, the sample prepared by soaking recycled aggregates in a 0.8% TiO<sub>2</sub>/LDHs suspension exhibits the highest photocatalytic degradation rate for NO gas, reaching 72.54%. Further investigation on the influence of environmental temperature reveals that, at 25 °C, the maximum photocatalytic degradation rate for NO gas is 72.9%. Moreover, at an illumination intensity of 40 W/m<sup>2</sup>, the maximum photocatalytic degradation rate for NO gas is 87.08%. Additionally, after three repeated photocatalytic tests, the sample demonstrates good stability, with a photocatalytic degradation rate of 58%. The nitrogen content in the eluent obtained from soaking the sample was determined to be 0.0022 mol/L, with a recovery rate of 80%. The adsorption experiment demonstrates that the sample exhibits a favorable adsorption effect on nitrate ions, reaching a maximum of 56.8%.</p>

错误：搜索内容不能为空，请输入英文关键词
错误：关键词超出字数限制，请精简
高级检索

Photocatalytic-adsorption Purification Performance of Pervious Concrete Containing TiO2/LDHs-loaded Recycled Aggregates for Gas Pollutants

  • 期刊论文

  • 发表日期：

    2025年4月14日

查看全文
  • Yidong Xu,
  • Zhihang Yang,
  • Shi-Tong Li,
  • Xiaoniu Yu

摘要

The degradation performance of pervious concrete containing TiO2/LDHs-loaded recycled aggregates for NO gas was analyzed using a gas phase catalytic degradation test device, simulating different environmental conditions such as load, ambient temperature, and illumination intensity, which provides theoretical support for practical engineering. The experimental results indicate that when the ambient temperature is controlled at 25 °C and the illumination intensity is 30 W/m2, the sample prepared by soaking recycled aggregates in a 0.8% TiO2/LDHs suspension exhibits the highest photocatalytic degradation rate for NO gas, reaching 72.54%. Further investigation on the influence of environmental temperature reveals that, at 25 °C, the maximum photocatalytic degradation rate for NO gas is 72.9%. Moreover, at an illumination intensity of 40 W/m2, the maximum photocatalytic degradation rate for NO gas is 87.08%. Additionally, after three repeated photocatalytic tests, the sample demonstrates good stability, with a photocatalytic degradation rate of 58%. The nitrogen content in the eluent obtained from soaking the sample was determined to be 0.0022 mol/L, with a recovery rate of 80%. The adsorption experiment demonstrates that the sample exhibits a favorable adsorption effect on nitrate ions, reaching a maximum of 56.8%.