Scholarlink

<p>In this work, the Tip/AXM310 composites were prepared by combining mechanical stirring and hot extrusion processes. The effect of different addition quantities of Ti particles on the microstructure and mechanical properties of xTip/AXM310 (<i>x</i> = 0, 1, 2, 3 wt.%) composites was investigated, and the strengthening mechanism of the composites was discussed. The results demonstrated that the addition of Ti particles can refine the grains and promote the precipitation of the second phase in the matrix. As the amount of added Ti particles increases, the grain size and texture intensity of the composites gradually decrease, while the recrystallization fraction gradually increases. During the homogenization process prior to extrusion, the second phase of the Tip/AXM310 composites is transformed from C36-(Mg, Al)<sub>2</sub>Ca to C15-Al<sub>2</sub>Ca. The 2% Tip/AXM310 composite exhibits the best mechanical properties, with a yield strength of 282&#xa0;MPa, an ultimate tensile strength of 302&#xa0;MPa, and an elongation of 14.2%. This represents significant improvements of 16.7, 38.9, and 36.5% respectively compared to the matrix alloy. The improvement in the yield strength of the composites is mainly attributed to a combination of grain refinement, Orowan strengthening, and thermal mismatch strengthening. The theoretical yield strength values of the composites calculated from the equations of the four strengthening mechanisms are basically consistent with the experimental values.</p>

错误：搜索内容不能为空，请输入英文关键词
错误：关键词超出字数限制，请精简
高级检索

Investigation on the synergistic improvement of strength and plasticity in Tip/AXM310 magnesium matrix composites fabricated by melt casting-extrusion process

  • 期刊论文

  • 发表日期：

    2025年2月19日

查看全文
  • Shenghao Hu,
  • Feng Wang,
  • Xudong Du,
  • Kai Kang,
  • Tijie Song,
  • Le Zhou,
  • Pingli Mao,
  • Jinwei Li

摘要

In this work, the Tip/AXM310 composites were prepared by combining mechanical stirring and hot extrusion processes. The effect of different addition quantities of Ti particles on the microstructure and mechanical properties of xTip/AXM310 (x = 0, 1, 2, 3 wt.%) composites was investigated, and the strengthening mechanism of the composites was discussed. The results demonstrated that the addition of Ti particles can refine the grains and promote the precipitation of the second phase in the matrix. As the amount of added Ti particles increases, the grain size and texture intensity of the composites gradually decrease, while the recrystallization fraction gradually increases. During the homogenization process prior to extrusion, the second phase of the Tip/AXM310 composites is transformed from C36-(Mg, Al)2Ca to C15-Al2Ca. The 2% Tip/AXM310 composite exhibits the best mechanical properties, with a yield strength of 282 MPa, an ultimate tensile strength of 302 MPa, and an elongation of 14.2%. This represents significant improvements of 16.7, 38.9, and 36.5% respectively compared to the matrix alloy. The improvement in the yield strength of the composites is mainly attributed to a combination of grain refinement, Orowan strengthening, and thermal mismatch strengthening. The theoretical yield strength values of the composites calculated from the equations of the four strengthening mechanisms are basically consistent with the experimental values.