Co-reinforcement of paper wet strength by refiner-treated pulp and NaOH treatment

We previously used a grinder to prepare cellulose nanofibers (CNFs) that were then added to pulp to improve the wet strength of paper, with subsequent alkali treatment further improving its wet tensile strength. However, mass production of CNF using ultra-fine grinders is not feasible; moreover, fabricating paper sheets by first preparing CNFs and adding them to pulp is a complex process. Therefore, in this study, we directly fibrillated pulp using a refiner instead separately preparing CNFs, with the refined pulp used to make paper sheets, thereby simplifying the process. The resulting dried sheets were subsequently treated with 8 and 16 wt% NaOH, after which the co-reinforcing effect of the refiner and NaOH treatments on the wet tensile strength of paper was examined. Unexpectedly, wet tensile strength of 39 and 45 MPa was achieved. These values are higher than values obtained using the CNFs and NaOH treatment, and comparable to the dry strength of untreated and unrefined pulp sheet. Moreover, the dewatering time of the refiner-treated pulp was significantly shorter than that of the CNF-mixed pulp, which reduces the time required to prepare paper. This study demonstrated that refiner-treated pulp is more suitable than CNF-mixed pulp for improving paper wet strength.