Scholarlink

<p>Carbon fiber-reinforced polymer (CFRP-T800/epoxy) stringers, particularly L-shaped, are widely used components in aircraft, necessitating efficient manufacturing solutions. This study addresses the fabrication challenges of L-shaped carbon fiber reinforced polymer stringers by automatic tape laying process and layer-by-layer roll forming, which is subsequently validated. The process begins with the creation of a CFRP pre-form flat blank via automatic tape laying process. A roll forming experimental platform is then set up, and a Box-Behnken design experiment is conducted to evaluate the effects of various process parameters including pre-form flat blank temperature, roll forming speed, roll forming pressure, and tension on the product quality. The roll forming of the resin-based CFRP thermoset L-shaped stringers produces components with measured outcomes of porosity, surface quality, and thickness uniformity. The experimental analysis demonstrates how these process parameters including pre-form flat blank temperature, roll forming speed, roll forming pressure, and tension influence porosity, thickness consistency, and bulging rate. Results show an optimal porosity of 0.0096%, a thickness standard deviation of 0.0212&#xa0;mm, and excellent surface quality; and the order of influence weights of process parameters on rolled quality is: pre-form flat blank temperature, roll forming speed, roll forming pressure, tension; optimal conditions determined include a blank temperature of 55–60&#xa0;°C, a rolling speed of 10.8&#xa0;mm/s, a rolling pressure of 0.2&#xa0;MPa, and a tension of 15&#xa0;N.</p>

错误：搜索内容不能为空，请输入英文关键词
错误：关键词超出字数限制，请精简
高级检索

Study on Roll Forming Process of Carbon Fiber Composite L-shaped Stringer

  • 期刊论文

  • 发表日期：

    2025年1月23日

查看全文
  • Hongxiao Wang,
  • Yi Zhang,
  • Wen Xiao,
  • Xiaohui Zhang,
  • Yanghang Wu,
  • Dengjie Zhu

摘要

Carbon fiber-reinforced polymer (CFRP-T800/epoxy) stringers, particularly L-shaped, are widely used components in aircraft, necessitating efficient manufacturing solutions. This study addresses the fabrication challenges of L-shaped carbon fiber reinforced polymer stringers by automatic tape laying process and layer-by-layer roll forming, which is subsequently validated. The process begins with the creation of a CFRP pre-form flat blank via automatic tape laying process. A roll forming experimental platform is then set up, and a Box-Behnken design experiment is conducted to evaluate the effects of various process parameters including pre-form flat blank temperature, roll forming speed, roll forming pressure, and tension on the product quality. The roll forming of the resin-based CFRP thermoset L-shaped stringers produces components with measured outcomes of porosity, surface quality, and thickness uniformity. The experimental analysis demonstrates how these process parameters including pre-form flat blank temperature, roll forming speed, roll forming pressure, and tension influence porosity, thickness consistency, and bulging rate. Results show an optimal porosity of 0.0096%, a thickness standard deviation of 0.0212 mm, and excellent surface quality; and the order of influence weights of process parameters on rolled quality is: pre-form flat blank temperature, roll forming speed, roll forming pressure, tension; optimal conditions determined include a blank temperature of 55–60 °C, a rolling speed of 10.8 mm/s, a rolling pressure of 0.2 MPa, and a tension of 15 N.