Efficacy of personalized 3D-printed osteotomy guide in maximizing fibular utilization and minimizing graft length for reconstruction of large mandibular defect

The study addresses the long-standing challenge of insufficient length in vascularized fibular flaps when reconstructing large mandibular defects that require dual-barrel grafts. Employing personalized 3D-printed osteotomy guides, the study aims to optimize fibular utilization and minimize the required graft length.

Two reconstruction methods for distal bone defects were compared: a fold-down (FD) group that employed a specialized osteotomy guide for folding down a triangular bone segment, and a traditional double-barrel (DB) group. Metrics for comparison included defect and graft lengths, as well as the graft-to-defect length ratio. Postoperative quality of life was assessed using the University of Washington Quality of Life questionnaire (UW-QoL).

Both FD and DB groups achieved successful mandibular reconstruction. Despite larger defects in the FD group (117 ± 31.35 mm vs 84 ± 35.34 mm, p = 0.028), the used fibula length was not statistically longer in the FD group. The median ratio of graft-to-defect length was also lower in the FD group (1.327 vs 1.629, p = 0.024), suggesting that FD required only 82.47% of the graft length needed in the DB approach. Quality of life scores post-surgery were comparable between the groups.

Personalized 3D-printed osteotomy guides enhance fibula graft efficacy for reconstructing larger mandibular defects, necessitating shorter graft lengths while preserving postoperative quality of life.

This study confirms the utility of 3D printing technology as an effective and precise tool in orthopedic surgery, particularly for complex reconstructions like large mandibular defects. It suggests a viable alternative that could potentially revolutionize current practices in bone grafting.