错误:搜索内容不能为空,请输入英文关键词
错误:关键词超出字数限制,请精简
高级检索

Lateralizing calcaneal osteotomy performed with a percutaneous burr results in a significantly lower increase in tarsal tunnel pressure

  • Ali A. Siddiqui,
  • Wesley D. Troyer,
  • Jugert Bango,
  • Moawiah S. Mustafa,
  • Jeannie F. Buckner,
  • Glenn G. Shi,
  • Edward T. Haupt

摘要

Purpose

Tarsal tunnel syndrome is well documented following lateralizing calcaneal osteotomy to manage varus hindfoot deformity. Traditionally, calcaneal osteotomy is performed with an oscillating saw. No studies have investigated the effect of alternative surgical techniques on postoperative tarsal tunnel pressure. The purpose of this study was to investigate the difference in tarsal tunnel pressures following lateralizing calcaneal osteotomy performed using a high-torque, low-speed “minimally invasive surgery” (MIS) Shannon burr versus an oscillating saw.

Methods

Lateralizing calcaneal osteotomy was performed on 10 below-knee cadaveric specimens. This was conducted on 5 specimens each using an oscillating saw (Saw group) or MIS burr (Burr group). The calcaneal tuberosity was translated 1 cm laterally and transfixed using 2 Kirschner wires. Tarsal tunnel pressure was measured before and after osteotomy via ultrasound-guided percutaneous needle barometer. Mean pre/post-osteotomy pressures were compared between groups. Differences were analyzed using Student’s t test.

Results

The mean pre-procedure tarsal tunnel pressure was 25.8 ± 5.1 mm Hg in the Saw group and 26.4 ± 4.3 mm Hg in the Burr group (p = 0.85). The mean post-procedure pressure was 63.4 ± 5.1 in the Saw group and 47.8 ± 4.3 in the Burr group (p = 0.01). Change in tarsal tunnel pressure was significantly lower in the Burr group (21.4 ± 4.5) compared to the Saw group (37.6 ± 12.5) (p = 0.03). The increase in tarsal tunnel pressure was 43% lower in the Burr group.

Conclusion

In this cadaveric study, tarsal tunnel pressure increase after lateralizing calcaneal osteotomy was significantly lower when using a burr versus a saw. This is likely because the increased width (“kerf”) of the 3 mm MIS burr, compared to the submillimeter saw blade width, causes calcaneal shortening. Given the smaller increase in tarsal tunnel pressure, using the MIS burr for lateralizing calcaneal osteotomy may decrease the risk of postoperative tarsal tunnel syndrome. Future research in vivo should explore this.