Magmatic water content in HIMU basalts from the Cook-Austral Islands: constraints on degassing processes and source composition from clinopyroxene phenocrysts

The amount of water recycled during subduction is unclear. Water/Ce estimates in HIMU (high-²³⁸U/²⁰⁴Pb) basalts are variable, ranging from < 100 to > 250 in glasses and melt inclusions. Because clinopyroxene (cpx) is a common early liquidus phase and the cpx/melt partitioning of water is well constrained, cpx phenocrysts provide an additional constraint on magmatic water contents. We present water and trace element concentrations in HIMU-basalt-hosted cpx phenocrysts from the Austral Islands. Calculated melt [H₂O] (up to 4.3 wt.%) and H₂O/Ce ratios (22–825) are higher than in olivine-hosted inclusions, as are estimated equilibration pressures. Correlation between estimated melt [H₂O] and crystallization or entrapment pressure suggests significant water loss during magma ascent. Most ocean island basalts (OIBs) span a limited range in H₂O (~ 1–1.5 wt.%), and low (< 100) H₂O/Ce ratios are primarily observed in melts with unusually high [Ce] (up to 350 ppm). Additionally, [H₂O] and H₂O/Ce in some suites correlate with entrapment pressure despite having quench pressures high enough to prevent significant water loss from open- or closed-system degassing (< 100 MPa). Polybaric “sparging”, whereby low-P melts re-equilibrate with CO₂-rich fluids exsolved at higher pressure, may result in water loss at pressures less than CO₂ saturation. This may more accurately describe OIB degassing processes than open or closed system degassing. After correcting for degassing, primary Australs melts likely have H₂O/Ce of ~ 300–600. If applicable to OIB sources in general, this limits the total water budget of the mantle, including the mantle transition zone, to < 2.4 ocean masses.