Pre-milling technique improves the accuracy of posterior femoral condyle cut and reduces the tibial recut in Oxford unicompartmental knee arthroplasty

Recuts are sometimes needed in UKA because of inadequate posterior tibial cut thickness. We investigated the efficacy of a pre-milling technique (the first milling is done prior to the posterior condylar cut) in Oxford unicompartmental knee arthroplasty to enhance bone cut thickness and to minimize tibial recuts.

Between January 2021 and January 2023, a posterior condyle cut was made before milling in 213 knees in 152 patients (conventional group), while the pre-milling technique was used in 198 knees in 140 patients (pre-milling group). The thickness of the posterior condyle and the rate of tibial recuts were compared between the groups.

The bone cut thickness was thinner in the conventional group than in the pre-milling group in small-size (4.7 mm ± 0.6 mm and 5.0 mm ± 0.6 mm, P = 0.0001) and in medium-size (5.1 mm ± 0.5 mm and 5.4 mm ± 0.5 mm, 0.0001) femoral components, whereas there was no difference in large-size femoral components. However, the thickness was still less than the component thickness (5.17 mm for small, 5.57 mm for medium and 6.17 mm for large) in both groups. Tibial recuts were more prevalent in the conventional group than in the pre-milling group (14 knees, 7%, 3 knees 2%, P = 0.002).

The pre-milling technique was found to increase the bone cut thickness in small and medium femoral components, reducing the need for tibial recuts. Further research is warranted to optimize the pre-milling technique and to investigate its long-term impact on patient outcomes.