Subharmonic ferroresonance mitigation in capacitive voltage transformer using meminductor

The nonlinear resonance between the saturated inductance of a transformer and capacitance of the switching device in a substation induces overvoltages and overcurrents. The voltage transformer experience 2–4 pu overvoltages due to the different modes of nonlinear resonance. Though many overvoltage suppression circuits are being proposed, the transformer does not have a single suppression circuit against all modes. A memristor-based suppression circuit has been proposed already for the fundamental (periodic) mode of ferroresonance. In this paper, an aperiodic mode of ferroresonance has been addressed with same memristive circuit along with meminductive circuit. A subharmonic mode of ferroresonance overvoltage of 3.13 pu has been induced in a (400 kV/ \(\surd {3}\) $\surd 3$ )/(110 V/ \(\surd {3}\) $\surd 3$ ) CVT model according to IEC 61869 -5 standards. The primary current got increased from 23.3 mA to 1.56 A and has subharmonic frequency components. A meminductor circuit is proposed as a suppression circuit against ferroresonance for a Substation CVT. A gas discharge lamp T8 Philips 18 W with low-frequency magnetic ballast emulated peculiar pinched hysteretic characteristics of a memristor. The relation between charge and flux termed as memristance of the memristor circuit is used to mitigate the nonlinear resonance oscillations. A mutator circuit for mitigation requirement has been connected to the lamp model to emulate meminductor characteristics. The mitigation performance shows that the meminductor circuit dominantly recovers the secondary voltage of CVT in 0.188 s with a reduction of 1/3rd, 1/5th, and 1/7th harmonic components by 35.4%, 78.15%, and 90.41%, respectively.