Scholarlink

<p>Micromachining is a small-scale machining process that enables the manufacturing of components with high dimensional and geometric precision. However, the micromilling of hard materials like H13 tool steel is challenging due to tool wear, surface integrity issues, and burr formation. This study experimentally evaluates the influence of feed rate on micromilling slots. The experiments employed (Al, Ti) N-coated end mills with a 400&#xa0;µm diameter. Cutting parameters included a constant spindle speed of 32,000&#xa0;rpm, an axial depth of 40&#xa0;µm, and three distinct feed per tooth values: 1, 5, and 10&#xa0;µm. Key performance indicators included tool wear, surface roughness (Ra), and burr characteristics. Results indicated that Ra values remained stable, fluctuating only between 0.118&#xa0;µm and 0.144&#xa0;µm, a behavior linked to the minimal tool wear observed. Regarding burr formation, wave-type, feather-type, and smaller burrs were identified, with larger formations occurring on the down-milling side. Notably, spheroidal chips formed during the micromilling of H13 tool steel.</p>

错误：搜索内容不能为空，请输入英文关键词
错误：关键词超出字数限制，请精简
高级检索

Experimental study on the influence of feed rate in micromilling of H13 tool steel

  • 期刊论文

  • 出版模式：

    开放获取

  • 发表日期：

    2026年3月21日

查看全文
  • Thaise Alonso,
  • Milla Caroline Gomes,
  • Márcio Bacci da Silva

摘要

Micromachining is a small-scale machining process that enables the manufacturing of components with high dimensional and geometric precision. However, the micromilling of hard materials like H13 tool steel is challenging due to tool wear, surface integrity issues, and burr formation. This study experimentally evaluates the influence of feed rate on micromilling slots. The experiments employed (Al, Ti) N-coated end mills with a 400 µm diameter. Cutting parameters included a constant spindle speed of 32,000 rpm, an axial depth of 40 µm, and three distinct feed per tooth values: 1, 5, and 10 µm. Key performance indicators included tool wear, surface roughness (Ra), and burr characteristics. Results indicated that Ra values remained stable, fluctuating only between 0.118 µm and 0.144 µm, a behavior linked to the minimal tool wear observed. Regarding burr formation, wave-type, feather-type, and smaller burrs were identified, with larger formations occurring on the down-milling side. Notably, spheroidal chips formed during the micromilling of H13 tool steel.