Combined rolling-extrusion of various billets from the Al–Ce–La alloy for electrical wire production

The rheological, mechanical, and electrical properties and structure of rods and wires made of aluminum alloy concentration of 1% REM (0.6% Ce and 0.4% La) are investigated and presented. The rods were produced by combined rolling-extrusion (CRE) from two different types of billets: casting into a mold 14×14 mm and into electromagnetic mold (EMM) Ø12.5 mm. A database of the DEFORM 3D complex was created for computer modeling of the CRE process. The tensile strength of rods Ø9 and 5 mm obtained using CRE method is 120–140 MPa and elongation to failure is 15–26% for billets from EMM. For billets 14×14 mm, the ultimate tensile strength is 112–125 MPa, which is comparatively lower than that of rods made from round billets (elongation to failure is 26–34%). The plastic properties of the final wire Ø2 mm from a round billet after EMM are higher than wire Ø2 mm from a billet obtained by casting into a mold 14×14 mm. Rods after CRE from both types of billets are characterized by fairly high ductility. To obtain Ø2-mm wire from rods, no intermediate annealing was required. The values of electrical resistance are taken from 0.02271 to 0.0301 Ω‧mm²/m for rods from 12.5-mm billets and from 0.02776 to 0.03413 Ω‧mm²/m for rods from billets 14×14 mm. The electrical resistance values for wire Ø2 mm from billets 14×14 mm are higher than for wire obtained from rods after EMM. Microstructure shows that the final wire after CRE from billet in EMM has a more extensive structure than after CRE from billets with dimensions of 14×14 mm.