Scholarlink

<p>The timber construction industry mainly uses softwood as structural products, owing to the slenderness of the trees and rather homogeneous nature of the timber, which makes it easier and more cost-effective to process compared to hardwood. By using narrower and shorter components than for softwood, it might be technically and economically possible to produce finger-jointed, edge-glued oak laminations to be used in glued laminated products. This study proposes to explore the impact of the shorter size of components and thus greater heterogeneity of oak edge-glued laminations on their structural properties. Homogenizing the elastic modulus of the components of the laminations through preliminary sorting appeared to greatly improve the strength of the edge-glued laminations, whereas the sole strength grading with no further control of elastic modulus variability could lead to low strengths with disadvantageous system effect. The local evaluation of the ratio between the lowest and highest MoE values of sub-boards in parallel across the lamination width proved to be correlated to tensile strength, with a coefficient of determination of <InlineEquation ID="IEq1"> <EquationSource Format="TEX">\(R^2\)</EquationSource> </InlineEquation> = 0.30. Moreover, homogenizing the elastic modulus of the laminations led to strengths corresponding to system factor values <InlineEquation ID="IEq2"> <EquationSource Format="TEX">\(k_{sys}\)</EquationSource> </InlineEquation> exceeding 1.1, as recommended by the standard. A better control of variability of the mechanical properties of hardwood products, seems offering a pathway to more efficient utilization of the hardwood resource.</p>

错误：搜索内容不能为空，请输入英文关键词
错误：关键词超出字数限制，请精简
高级检索

Influence of the stiffness heterogeneity on the tensile strength of finger-jointed and edge-glued oak laminations

  • 期刊论文

  • 出版模式：

    开放获取

  • 发表日期：

    2026年2月18日

查看全文
  • Delin Soh Mbou,
  • Guillaume Pot,
  • Joffrey Viguier,
  • Bertrand Marcon

摘要

The timber construction industry mainly uses softwood as structural products, owing to the slenderness of the trees and rather homogeneous nature of the timber, which makes it easier and more cost-effective to process compared to hardwood. By using narrower and shorter components than for softwood, it might be technically and economically possible to produce finger-jointed, edge-glued oak laminations to be used in glued laminated products. This study proposes to explore the impact of the shorter size of components and thus greater heterogeneity of oak edge-glued laminations on their structural properties. Homogenizing the elastic modulus of the components of the laminations through preliminary sorting appeared to greatly improve the strength of the edge-glued laminations, whereas the sole strength grading with no further control of elastic modulus variability could lead to low strengths with disadvantageous system effect. The local evaluation of the ratio between the lowest and highest MoE values of sub-boards in parallel across the lamination width proved to be correlated to tensile strength, with a coefficient of determination of \(R^2\) = 0.30. Moreover, homogenizing the elastic modulus of the laminations led to strengths corresponding to system factor values \(k_{sys}\) exceeding 1.1, as recommended by the standard. A better control of variability of the mechanical properties of hardwood products, seems offering a pathway to more efficient utilization of the hardwood resource.